Short answer
To insulate against or get rid of condensation damp on a wall, you have to make sure its inner surface is not cold and that the indoor air does not hold too much vapour: good thermal insulation that eliminates the thermal bridges is combined with sufficient ventilation, and then the mould is cleaned off and anti-mould paint is applied.
How to identify condensation
- It appears in winter and in the cold areas: corners, junctions with ceilings and floor slabs, around windows, behind wardrobes and in bedrooms and bathrooms.
- It produces black mould in spots or diffuse stains, droplets on the window panes and a damp smell.
- It does not depend on rain (as penetrating damp does), nor is it limited to the lower part of the wall (as rising damp is).
Effective solutions
- Thermal insulation of the wall:
- From the inside: dry lining with plasterboard and insulation (mineral wool, extruded polystyrene or panels with a vapour barrier), or insulating panels bonded with mortar. It is the usual option in a flat.
- From the outside: an external thermal insulation system (ETICS), the most effective solution because it eliminates the thermal bridges at the slab edges and columns. In a block of flats it requires the agreement of the homeowners’ association.
- Injection of insulation into the cavity, if the wall has one.
- Ventilation: ventilate daily, fit air vents or extractor fans in bathrooms and the kitchen, or controlled mechanical ventilation. The Spanish Technical Building Code (DB HS 3) requires sufficient ventilation in homes.
- Vapour control: do not dry clothes indoors without ventilating, use the cooker hood and keep the temperature stable.
- Remove the mould with fungicidal products and paint with anti-mould paint once the cause has been dealt with.
A dehumidifier helps, but it does not correct the thermal bridge; if the wall stays cold, the condensation comes back.
When it is a claimable construction defect: if in a new home the condensation is due to a lack of insulation, unresolved thermal bridges or insufficient ventilation, the Spanish Technical Building Code is breached (basic documents HE and HS). These are habitability defects for which the developer, the builder and the technical professionals are liable for three years from the acceptance of the works (art. 17 of the Spanish Building Act), with two years to claim. In rented homes with condensation caused by defects in the property, the landlord must carry out the habitability repairs (art. 21 of the Spanish Urban Leases Act).
An expert report with thermal imaging makes it possible to tell whether the cause is the way the home is used or a construction defect, which is what determines who pays. At DPCON we prepare it and make the claim when appropriate.
Updated on 17 November 2026.
This answer is general information and is no substitute for advice on your specific case.
You may be interested in: Condensation
Are you in this situation?
Tell us briefly about your case and we will let you know whether we can help.
Other questions that may help you